Peer-Reviewed Journal Details
Mandatory Fields
Zhao, L; Collins, MN; Birkinshaw, C
2009
March
Journal Of Chemical Technology And Biotechnology
Development of the powder reaction moulding process
Published
()
Optional Fields
powder forming sintering cyanoacrylate moulding compression forming ALKYL CYANOACRYLATES VISCOSITY-CONCENTRATION NEWTONIAN SUSPENSIONS SPHERICAL PARTICLES TERTIARY-AMINES POLYMERIZATIONS KINETICS ACIDS
84
3
454
460
BACKGROUND: The powder reaction moulding process uses a reactive monomer as carrier and binder for the moulding of metal or ceramic powders. De-binding is achieved using thermal depolymerisation which is followed by sintering to give the finished component. Binder can be recovered for re-use. RESULTS: Moulding compounds, with various powder volume fractions, have been prepared using stainless steel, silicon nitride and alumina with n-butyl cyanoacrylate as binder, and the stability of the compounds established. Rheological properties of the compounds have been measured using both pressure flow and drag flow methods. Compounds are strongly pseudoplastic. Comparison of experimental results with theoretical models, describing suspension flow behaviour shows that experimental maximum volume fractions are close to the theoretical volume fraction of 0.42 for silicon nitride, 0.68 for alumina and 0.7 for stainless steel. Differential scanning calorimetry and thermogravimetry have been used to simulate de-binding and show a rapid loss of binder through depolymerisation. Post-sintering porosity of the ceramic materials is high but this is thought to arise from the low pressure moulding techniques used. Porosity of the stainless steel mouldings is much lower. CONCLUSIONS: The results validate the powder reaction moulding idea and demonstrate applicability to three widely different powder materials. (C) 2008 Society of Chemical Industry
0268-2575
10.1002/jctb.2063
Grant Details